Water Record Residential water, on the record.

The Anode Rod: The Part That Corrodes So Your Tank Doesn't

reference · published 2026-11-21

This page opens the heating division with the component that connects it to the rest of this site: the water heater’s anode rod. It is read from the Minnesota Department of Health’s hydrogen sulfide page (health.state.mn.us, accessed 2026-11-21) — the same regulator source behind the rotten-egg diagnosis and the sulfur treatment guide.

What it is

Per MDH: a metal rod — usually magnesium, 1/2 to 3/4 inches in diameter and 30 to 40 inches long — hanging from a plug on top of the tank, installed to reduce corrosion of the water heater tank. It works by being the thing that corrodes instead. That’s the whole job, and it’s why removing it is costly: MDH warns removal “may significantly decrease the life of the water heater.”

The side effect that brings people here

MDH describes two ways a water heater manufactures rotten-egg smell: it keeps water warm enough for sulfur bacteria to live, and the magnesium anode “can supply electrons that aid in the conversion of sulfate to hydrogen sulfide gas.” That’s why the hot-vs-cold faucet test matters so much — smell in the hot water only points at the tank and its rod, not the well.

MDH’s three fixes, with their fine print

  1. Replace the anode with a different material. MDH’s framing is careful and worth keeping: a replacement anode such as aluminum “may provide corrosion protection without contributing to the production of hydrogen sulfide gas.” Swap, don’t remove — protection stays, the electron supply changes.
  2. Chlorinate and flush the tank. Kills the sulfur bacteria — with MDH’s honesty note that if any survive, the smell can return within weeks.
  3. Run the tank at 160°F for several hours, then flush. MDH wraps this one in a hard caution: verify an operable pressure relief valve first, and lower the thermostat afterward against scalding and energy cost. Their general advice for all of it: unless you’re very familiar with water heater work, this is a plumber’s job.

What this page holds back

Anode selection by brand, powered-anode products, and replacement walk-throughs wait for the heating equipment layer and verified listings — nothing is sold from this page. If the smell is in both hot and cold water, the problem isn’t this rod at all; start at the diagnosis page and let the hot-vs-cold split route you.